Windows WSL Toolchain
This development environment is not supported. See Toolchain Installation for information about the environments and tools we do support!
Windows users can alternatively install a slightly modified Ubuntu Linux PX4 development environment within Bash on Windows, and use it to:
Build firmware for NuttX/Pixhawk targets.
Run the PX4 JMAVSim simulation (using a Windows-hosted X-Windows app to display the UI)
This mechanism only works on Windows 10. It essentially runs the toolchain in a virtual machine, and is relatively slow compared to other solutions.
Setup Environment
The easiest way to setup the environment is to use the windows_bash_nuttx.sh script (details for script are given below).
To setup the development environment:
Install Bash on Windows.
Open the bash shell.
Download the windows_bash_nuttx.sh:
wget https://raw.githubusercontent.com/PX4/Devguide/master/build_scripts/windows_bash_nuttx.sh
Run the script using the command below (acknowledging any prompts as required):
Build Firmware
To build the firmware (i.e. for px4_fmu-v4):
Enter the following commands in the bash shell:
On successful completion you'll find the firmware here:
PX4-Autopilot/build/px4_fmu-v4_default/px4_fmu-v4_default.px4
The make
commands to build firmware for other boards can be found in Building the Code.
You can flash the custom firmware on Windows using QGroundControl or Mission Planner (it is not possible to directly flash the firmware from within the bash shell using the
upload
command).
Simulation (JMAVSim)
Bash on Windows does not include support for UI libraries. In order to display the jMAVSim UI you will first need to install an X-Window application like XMing into Windows.
To run JMAVSim:
Install and start XMing on Windows.
Enter the following command in the bash shell:
Add this line to the Ubuntu .bashrc file if you don't want to enter it every session.
Start PX4 and jMAVSim in the bash shell:
The JMAVSim UI is then displayed in XMing as shown below:
Gazebo can similarly be run within Ubuntu Bash for Windows, but too slow to be useful. To try this, follow the ROS kinetic install guide and run Gazebo in the Bash shell as shown:
Build Script Details
The windows_bash_nuttx.sh build script modifies the Ubuntu build instructions to remove Ubuntu-specific and UI-dependent components, including the Qt Creator IDE and the simulators.
In addition, it uses a 64 bit arm-none-eabi compiler since BashOnWindows doesn't run 32 bit ELF programs (and the default compiler from https://launchpad.net/gcc-arm-embedded
is 32 bit).
To add this compiler to your environment manually:
Download the compiler:
Unpack it using this command line in the Bash On Windows console:
This will unpack the arm gcc cross-compiler to:
Add the to the environment (add the line to your bash profile to make the change permanent)
Last updated