基本配置
This section describes the standard software configuration and calibration that is required for all PX4 vehicles.
The sub topics cover each of the steps in detail (first install the PX4 firmware and set your vehicle airframe):
Airspeed (primarily for fixed-wing/VTOL)
Flight Modes (Optional)
Battery (optional)
Safety (optional)
视频教程
The video below shows the calibration process in detail (this uses an older version of QGroundControl, but most of the process is unchanged).
Advanced Configuration
If your selected airframe configuration is a specific vehicle model (e.g. Holybro s500) then it may benefit from fine tuning, but this is not generally required.
If you're using a new airframe, a "generic" airframe, significantly modifying an airframe, or using less common sensors then see:
Advanced Configuration: Vehicle-specific tuning, fine tuning, factory-level configuration.
Flight Controller Peripherals - Hardware and software setup related to specific hardware (in particular lesser-used sensors).
Support
If you need help with the configuration you can ask for help on the QGroundControl Support forum.
Further Information
Last updated